Use the buttons on your Spottune Stream to enable Stereo Mode, play both channels across two zones and set the volume of each zone.
What Stereo Mode does
A stereo signal has two channels, Left (L) and Right (R). With Stereo Mode enabled and Zone 1+2 selected, the Stream plays one channel in each zone. Before you start, make sure you have speakers assigned to both zones and a source that provides both channels.
Create a stereo listening area
Use this setup when you want to hear the left and right parts of the same recording from different sides of a room. Assign the speakers on one side to one zone and the speakers on the other side to the other zone. Play a left/right test track to check that each channel plays on the intended side.
Play different content in two areas from one input
Use a player or mixer that can put different audio on its left and right outputs. For example, send background music on L and a spoken loop on R, then connect both channels to one stereo input on the Stream. Each zone plays the content carried by its channel. Check which zone plays each channel before assigning the content to your areas.
Both feeds need to reach the Stream together through the same input. If you use a mixer, route each feed to only its intended channel and check the output in stereo before connecting it. See available inputs on the Stream.
Enable Stereo Mode on the Stream
Enter Working Mode. Press and hold Play/Pause for 5 seconds, until the display shows WORKING MODE.
Open Stream settings. Press Source once.
Find Audio Mode. On the circular control panel, press Volume Down (−) 14 times from the top of the settings menu. Check that the cursor is next to AUDIO MODE before continuing.
Open Audio Mode. Press Play/Pause once to open the highlighted setting.
Select Stereo and save. Use the volume buttons on the control panel to change Mono to Stereo. Press Play/Pause once to confirm.
Leave Stream settings. Press Source once.
Exit Working Mode. Press and hold Play/Pause for 5 seconds to return to the Landing display.
For help finding the buttons, see Buttons on Your Spottune Stream.
Select Zone 1+2 to use Stereo Mode
On the normal playback screen, press Zone until the display shows Zone 1+2. This selection is required for Stereo Mode to operate across both zones.
To confirm the setup, start at a low volume and play a signal with a clearly identifiable left and right channel. Listen in both zones. For a two-content setup, play each feed on its own first, then play both together and check the result in both areas.
Adjust the volume of each zone
Press Zone until the display shows Zone 1, then use + or − to set its volume.
Select Zone 2 and set its volume the same way.
Return to Zone 1+2 to continue using Stereo Mode. Listen to both zones to check the balance.
If you hear the same audio in both zones or only one zone plays
Check that AUDIO MODE is set to Stereo and the playback display shows Zone 1+2.
Check that the source provides distinct left and right signals. For a wired source, check the stereo cable and the source or mixer routing.
If a zone is silent, check its volume and speaker assignment, then return to Zone 1+2 and test again. If your zone is still silent, read our article My speakers are not playing for futher troubleshooting.


